Firmware Streams
Auto Advance Cyclops
Automatically advances duration of Blue slot by 1 minute per run, stopping at 30 minutes.
Will only advance if at least 16 hours has passed since start of previous run.
Brightness steps Low/Low-Med/Med/High (for 1-4, scaling values 1, 1.25, 1.5, 2), high brightness 5-10 is Low/Med/High (1, 1.5, 2) then repeat.
Cyclops mode only ever lights one LED (and the IR LED for multicolour units).
Auto Advance
FW version 1.4.2: Automatically advances duration of Purple and Blue slots by 1 minute per run. Incrementing stops at 30 minutes. Will only advance once per day (checks that at least 16 hours has passed since start of previous run). Brightness 1-4 = Low/Med/High/High (1, 1.5, 2, 2) on coloured lights or single large LED at lower intensity on most recent production. Brightness 5-7 = Low/Med/High on one large LED. Brightness 8-10 = Low/Med/High on both large LEDs.
Dev-C
Another development stream. (Currently 1.3.11) Has 4.05V charge cap.
Brightness steps Low/Med/High/High (for 1-4, scaling values 1, 1.5, 2, 2), high brightness 5-10 is Low/Med/High on one, then Low/Med/High on both.
Low brightness only lights one LED on the red-only models. (SN 4000 and higher.)
Charge Cap 4.20V
Low-power version with charging cap set to 4.20V. Gain capped at 3x.
Factory 1.2.11
v1.2.11 as installed by factory, so devices won't update when Randy tests them.
Charge Cap 4.05V
Low-power version with charge cap set to 4.05V. Gain limited to 3x
Charge Cap 4.00V
Low-power version with charging cap set to 4.00V. Gain capped at 3x.
Cyclops
Only uses 1 bright LED on 5-10, red+IR on 1-4 (old HW, just one LED on new HW). Brightness scaling 1/2/3/4, and 9-10 = 8.
Full 3 Phase
All 3 phases are controllable for frequency, duration and brightness.
Also has battery improvements, and special UI display for 'empty' devices.
Looper
Purple-Blue looping indefinitely (10 brightness levels)
Purple-Blue-Orange; 10 levels
Purple-Blue-Orange; 10 levels
Two Phase
Health for 30 minutes and then Wellness for the time specified by the app (8 hours default)
Two Phase all Coloured
Health mode delivered through the coloured LEDs.
Three Phase all Coloured
Wellness, then Health (also on Coloured LEDs), then Support (steady on coloured LEDs)
Three Phase
Wellness, then Health, then Support (steady multicolour)
Dev-B
Alternate development/test stream.
Beta Bright
Beta firmware with 4x PWM brightness
Beta Dim
Beta testing with 1x bright PWM
Dev
For testing new versions of firmware